Technical Specifications for Cisco 7200 VXR Series

Description	Cisco 7204 VXR	Cisco 7206 VXR
Supported network interfaces	Ethernet 10BaseT and 10BaseFL Fast Ethernet 100BaseT (RJ-45 and MII) Gigabit Ethernet Token Ring (half and full duplex) Synchronous serial ISDN BRI/PRIHSSIT3/E3 Multichannel T1/ ISDN PRI Multichannel E1/ ISDN PRI Multichannel T3, E3 Multichannel STM-1 Packet Over SONET (POS) Dynamic Packet Transport (DPT) ATM (single-mode and multimode) ATM-CES Digital Voice Port Adapter, Enhanced Mix-enabled T1/E1 Integrated Service Adapter (ISA) VPN Acceleration Module (VAM)	Ethernet 10BaseT and 10BaseFL Fast Ethernet 100BaseT (RJ-45 and MII) Gigabit Ethernet Token Ring (half and full duplex) Synchronous serial ISDN BRI/PRIHSSIT3/E3 Multichannel T1/ ISDN PRI Multichannel E1/ ISDN PRI Multichannel T3, E3 Multichannel STM-1 Packet Over SONET (POS) Dynamic Packet Transport (DPT) ATM (single-mode and multimode) ATM-CES Digital Voice Port Adapter, Enhanced Mix-enabled T1/E1 Integrated Service Adapter (ISA) VPN Acceleration Module (VAM)
Power supplies (AC or DC)	2	2
Port adapter slots	4	6
Input/Output controller	Gigabit Ethernet + Ethernet Two-port 10/100 Ethernet (autosensing) Single-port Fast Ethernet	Same as 7204 VXR
Processor Memory	128MB (default) 256MB (max for NPE-225/NPE-300) 512MB (max for NPE-400/NSE-1)	Same as 7204 VXR
PCMCIA Flash memory card (optional, 2 slots available)	48 MB, expandable to 128 MB	Same as 7204 VXR
Port Adapter Capacity	4 port adapters	6 port adapters
Midplane	2 primary PCI buses and 1 secondary PCI bus with an aggregate bandwidth of 1.2 Gbps	Same as 7204 VXR
Standard components	Four slots for port adapters and service adapters Subchassis with midplane AC-input power supply AC power supply AC power cord	Six slots for port adapters and service adapters Subchassis with midplane AC power supply AC power cord

Power Requirements for Cisco 7200 Series

Description	Cisco 7204 VXR	Cisco 7206 VXR
AC-input power	370W max. (single or dual power supply configuration)	Same as 7204 VXR
AC-input voltage rating	100 - 240 VAC wide input with power factor correction	Same as 7204 VXR
AC-input current rating	Not to exceed 5A max. at 100 VAC and 2.5A max. at 240 VAC with the chassis fully configured	Same as 7204 VXR
AC-input frequency rating	50/60 Hz	Same as 7204 VXR
AC-input cable	18 AWG 3-wire cable, with 3-lead IEC-320 receptacle on the power supply end, and a country-dependent plug on the power source end	Same as 7204 VXR
DC-output power	280W max. (single or dual power supply configuration)	Same as 7204 VXR
DC-input power	370W max. (single or dual power supply configuration)	Same as 7204 VXR
DC-input voltage rating	-24 to -60 VDC for global DC power requirements	Same as 7204 VXR
DC-input current rating	Not to exceed 13A max. at --48 VDC (370W/-48 VDC = 7.7A typical draw) Not to exceed 8A max. at -60 VDC (370 W/-60 VDC = 6.2A typical draw)	Same as 7204 VXR
DC voltages supplied and maximum steady-state current ratings	+5.2V @ 360A +12.2V @ 9A -12.0V @ 1.5A +3.5V @ 13A	Same as 7204 VXR
DC-input cable	14 AWG recommended minimum, with at least 3 conductors rated for at least 140°F (60°C)	Same as 7204 VXR
Frequency	50/60 Hz	Same as 7204 VXR
Airflow	~80 cfm	Same as 7204 VXR
Power dissipation	~370W max. configuration	Same as 7204 VXR
Heat dissipation	370W (1262 BTUs)	Same as 7204 VXR

Software Specifications for Cisco 7200 Series

Description	Cisco 7204 VXR	Cisco 7206 VXR
Software requirement	Cisco IOS Release 11.1(16) CA or later, 11.2(11)P or later, or 11.3(1) or later.	Same as 7204 VXR